MELTRIC Switch-Rated Plugs: The Plug Is the Disconnect

Swap a motor in minutes, under load, without waiting on an electrician or suiting up in arc flash gear.

What it is

MELTRIC Switch-Rated plugs and receptacles combine a plug, a receptacle, and a non-fusible disconnect switch in one device. Your crew switches it off, pulls the plug, plugs in the spare, and the line is back online.

Hardwired vs. MELTRIC

Swapping a hardwired motor means locking out at the disconnect, suiting up in arc flash PPE, testing for voltage, unwiring the old motor, wiring in the new one, and waiting on an electrician for most of it. A MELTRIC-equipped motor skips all of that.

Why plants switch

  • Drop the separate disconnect: UL/CSA listed for motor circuit and branch circuit disconnect switching, and meets the NEC line-of-sight requirement, so you skip the extra safety switch and interlock
  • Connect and disconnect under load: enclosed arc chambers contain the arc, and a dead-front shutter blocks access to live parts once the plug comes out
  • Cut changeout downtime up to 50%: pre-wire the spare, then unplug the old motor and plug in the new one
  • Built for washdown and wear: silver-nickel butt contacts resist wear, welding, and corrosion, and the DSN Series is watertight up to Type 4X / IP69K with built-in lockout/tagout

Where it pays off fastest

Pump and conveyor motors, critical motors with a shelf spare, welders and portable equipment, and washdown areas.

BOTTOM LINE  Tell us the motor that costs you the most downtime. We will size the right MELTRIC device, quote it, and can send your next repaired or replacement motor back pre-wired and ready to plug in.
​​​​​​​

Contact Us Now

Reach out to us today and let's get your operations humming smoothly again. No problem is too big or too small for our seasoned team of technicians. Your satisfaction is our top priority, and we're committed to delivering prompt, reliable, and top-notch service every time.